New Grower SS Himalayan Blue Diesel Remo Nute DWC

[Cardinal]

Now the measurements and ph

Ph of straight well water

 

[Cardinal]

Ppm are @ 40

 

[Cardinal]

Now add the Nutrients

 

[Cardinal]

Alright the measurements:

Remo Nutrients
Micro 27.5 mL
Grow 27.5 mL
MagNifiCal 20 mL
Nature's Candy 27.5 mL
VeloKelp 20 mL
Cyco Kleanse 20 mL

Each one was poured in the tank by themselves (don't mix before putting in, it can change the nutes chemical make up)

 

[Cardinal]

The ph and ppm

 

[Cardinal]

I will be checking the ph and stuff again in about 15 to 30 mins

 

[Cardinal]

Checked ph and was at 6.8, then I used ph down (from GH) and used 2.5 mL. Adjusted to 6.2

 

[Cardinal]

Height check

A is 8 in tall
B is 6.5 in tall
C is 2.5 in tall
D is 2.75 in tall

 

[Quitexcellent]

Not sure if this is the best possible way but im always lowering my pH first down to like 5- 5.2 and after that i add the nutrients!

 

[Cardinal]

While researching this topic "ph before adding nutes or after adding nutes" I have done a it a couple of ways. Ph before adding nutes then wait and check, or add nutes then ph. I guess it's personal preference, as long as in the end your ph is within range. The way I look at it though is if you ph before adding nutes and then adjust again afterwards, the ppms are higher cause of the adding of ph up (or ph down) twice.

Your water type also plays a roll I think also. Mine is well water and is usually ph 7.0-7.3 and ppm are usually at 40-45